Zapco Z-series D - Manual (Page 8)

Z-1KD
Z-2KD / Z-3KD
First make the ground connection, then +12V wire connection, and finally the remote connection.
NOTE: The +12V wire must always be fused at the battery for protection against possible
damage. If you need to replace the power fuse, replace it with a fuse of the same value.
It may result in a serious hazard to use a fuse of a different type or rating.
Caution
+12V Power
Disconnect the battery ground, then, connect the +12V terminal of the amplifier to the + terminal of
the battery using the appropriate diameter cable, in-line fuse holder at the battery + terminal.
Remove the fuse from the holder before installation and replace only after all connections are completed.
GROUND
Disconnect the battery and connect the GND (ground) terminal to the cars fame or chassis the same
gauge wire as the positive cable. Keep this cable as short as possible.
Make sure that the connection with the frame of chassis is rust free and clear of paint or grime.
REMOTE
Connect the REM terminal of the amplifier to the power antenna terminal in the car ignition switch
using 142 or 16 ga. electrical wire.
Caution
This amplifier is not supplied with internal
fuse
ing. Make sure you install an in-line
fuse holder from the +terminal of battery.
Recommend 200 Ampere fuse.(Z-2KD)
Recommend 300 Ampere fuse.(Z-3KD)
to REMOTE Turn-on
from HEAD UNIT
Caution
This amplifier is not supplied with internal
fuse
ing. Make sure you install an in-line
fuse holder from the +terminal of battery.
Recommend 100 Ampere fuse.
BATTERY HEAD UNIT
POWER CONNECTION
GROUND
GROUND
to REMOTE Turn-on
from HEAD UNIT
BATTERY
HEAD UNIT
GROUND
GROUND
-7-