Verifying atm configuration – Cisco 1-PORT G.SHDSL 2600 User Manual
Page 6
1-Port G.SHDSL WAN Interface Card for Cisco 2600 Series Routers
Configuration Tasks
6
Cisco IOS Release 12.2(4)XL
Configuring ILMI on the DSLAM Connected to the G.SHDSL WIC
The ILMI protocol allows DSLAMs to be used for ATM address registration across an ATM
User-Network Interface (UNI). If ILMI is configured on the G.SHDSL WIC, the ATM PVC must be
configured on the DSLAM. All switch terminating connections use interface 0/0 to connect to the switch
CPU.
For information about configuring the DSLAM, see the
Verifying ATM Configuration
Use the following commands to verify your configuration:
•
To verify current configuration and to view the status for all controllers, use the show
running-config command.
•
To view ATM controller statistics, use the show controllers atm slot/port command.
•
To verify the PVC status, use the show atm vc command. Make sure that active PVCs are up.
•
To help identify ATM related events as they are generated, use the debug atm events command.
•
To indicate which interfaces are having trouble, use the debug atm errors command.
•
To identify an entry for the ATM interface you configured and to show an entry for the ATM slot/port
you configured, use the show ip route command.
•
To view the status of ATM interface, use the show interface atm command. Make sure that the ATM
slot/port and the line protocol are up, as shown in the following example:
Router# show interface atm 1/0
ATM1/0 is up, line protocol is up
Hardware is DSLSAR (with Globespan G.SHDSL Module)
MTU 4470 bytes, sub MTU 4470, BW 800 Kbit, DLY 2560 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ATM, loopback not set
Keepalive not supported
Encapsulation(s):AAL5 AAL2, PVC mode
24 maximum active VCs, 256 VCs per VP, 2 current VCCs
VC idle disconnect time:300 seconds
Last input never, output 00:00:01, output hang never
Last clearing of "show interface" counters 03:16:00
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
2527 packets input, 57116 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
10798 packets output, 892801 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Router# show atm vc
Step 14
Router> show interface atm 1/0
Verifies the ATM interface configuration.
Step 15
Router clear interface atm 1/0
Permits the configuration changes to take effect.
Command
Purpose