Carrier WEATHERMASTER III 38HQ User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Outdoor Fan Adjustment
— Required fan posi
tion is shown in Fig. 16. Adjust fan by loosening set
screws and moving fan blades up or down.
Fig. 16 — Condenser Fan Position
FAN MOTOR REMOVAL
1. Shut off power to outdoor coil.
2. Remove top cover (grille). Open or remove
service door. Remove junction box cover.
3. Disconnect fan motor leads in line-voltage sec
tion of junction box. See Fig. 14.
4. Remove fan from motor shaft by loosening
setscrews and pulling upward on fan hub.
5. Remove bolt holding fan motor to motor mount
ing bracket. Remove motor with wiring thru
top of unit.
To replace motor: place motor on motor mount
ing bracket and retighten bolt.
Before replacing metal fan, be sure rain shield
(Fig. 16) is in place on motor shaft.
Fig. 17 — Carrier Compatible Fitting
16