Before a self-cleaning cycle, How to set oven for cleaning, Operating the self-cleaning oven – Sears KENMORE 73318 User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Operating the Self-Cleaning Oven

Before a Self-Cleaning Cycle

step 1: Remove the broiler pan, broiler rack, ail cook­
ware and any aluminum foil from the oven—they can’t
withstand the high cleaning temperatures, {Oven
shelves may be left in oven. Note: Shelves will discol­
or during the self-cleaning cycle.)

Step 2: Wipe up heavy soil on the oven bottom.

A. Oven Front Frame

B. Oven Door Gasket

C. Oven Light

Step 3: With a dampened doth, clean spatters or
spills on oven front frame (A) and only that area on
the oven door that is outside the gasket (B). Do not
clean the gasket. Polish cleaned areas with a dry
cloth. Never use a commercial oven cleaner in or
around the seif-cleaning oven.

Step 4: Close the door and make sure the oven light
(C) is off.

Oven shelves may be cleaned in the self-cleaning
oven. However, they will darken, lose their luster and
become hard to slide. To make shelves siide more
easily, after each self-cleaning cycle, dampen fingers
with a smal! amount of cooking oil and rub lightly over
edges of shelf that contact shelf supports.

if your range is equipped with porcelain enamel drip
pans, you can dean them in the self-cleaning oven.
After wiping off any boilovers that are not stuck on,
place one pan upside down on each oven shelf.

Do not use commercial oven cleaners or oven protec­

tors in or near the self-cieaning oven. A combination
of any of these products plus the high clean cycle
temperatures may damage the porcelain finish of the
oven.

Important: The oven door must be closed and
latched and all controls must be set correctly for the
self-cleaning cycle to work properly.

How to Set Oven for Cleaning

step 1: Push in and turn
OVEN SET and OVEN
TEMP knobs In a clock­
wise direction to CLEAN.
Controls will snap into final
position when the CLEAN

location is reached.

O* AIIH

a

IH

a

lAtr'H

handle to the right as far

as it wilf go.

Step 3: Set the automatic
oven timer:

* Make sure

range clock

both the

and the

DELAY START dial show

the correct time of day.
When pushed in and
turned, the DELAY START dial and the STOP TIME
dial will "pop” into place when the time shown on the

range clock is reached,

«Decide on cleaning hours necessary.

Recommended Cleaning Time:

Light to Moderate Soil—2-3 hours
{thin spills and light spatters)

Heavy Soil—4 hours
(heavy, greasy spills and spatters)

® Add these hours to present time of day, then push in
and turn STOP TIME dial ciockwise to this desired
stop time.. CLEANING light glows, showing cleaning

has started.

The CLEANING iight will glow, indicating oven is hot,
and door cannot be opened. Oven door gets hot dur­

ing seif-cleaning. DO NOT TOUCH,

26

Advertising
This manual is related to the following products: