Sears KENMORE 73318 - Manual (Page 8)

Usage Situations Where Appliance Power Cord
Will Be Disconnected FREQUENTLY:
Do not use an adapter plug in these situations
because disconnecting of the power cord places
undue strain on the adapter and leads to eventual fail­
ure of the adapter ground terminal The customer
should have the two-prong wall receptacle replaced
with a three-prong (grounding) receptacle by a quali­
fied electrician before using the appliance.
The installation of appliances designed for mobile
home installation must conform with the Manufactured
Home Construction and Safety Standard, Title 24
CFR, Part 3280 (formerly the Federal Standard for
Mobile Home Construction and Safety, Title 24, HUD,
Part 280) or, when such standard is not applicable,
the Standard for Manufactured Home Installations, lat­
est edition (Manufactured Home Sites, Communities
and Set-Ups), ANSI A225.1, latest edition, or with
lACfSl CAripC! IL/UCli UL/LiCS-D.
Eiectricai Disconnect
1. Locate disconnect
p!ug at left rear of
burner box on the
range back,
2. Pinch sides of con­
nector and pull out of
range back.
Step 4
Seal the Openings
Seal any openings in the wail behind the range and in
the floor under the range when hookups are completed.
Step 5
Check Ignition of Surface Burners
Operation of all cooktop and oven burners should be
checked after range and gas supply lines have been
carefully checked tor leaks.
Select a top burner knob and simultaneously push In
and turn to LITE position. You will hear a snapping
sound indicating proper operation of the spark mod­
ule. Once the air has been purged from the supply
lines, burners should light within 4 seconds. After
burner lights, rotate knob out of the LITE position. Try
each burner in succession until all burners have been
checked.
Quality of Flames;
The combustion quality of burner flames needs to be
determined visually
(A) Yellow flames-
Call for service
(B) Yellow tips on
outer cones—
Normal for LP gas
Normal for natural gas
• If burner flames look like (A), call for seivice. Normal
burner flames should look like (B) or (C), depending
on the type of gas you use.
* With LP gas, some yellow tipping on outer cones is
normal.
Check Ignition of Oven Burner
Your oven is designed to operate quietly and automati­
cally. To operate the oven, turn the OVEN SET knob to
BAKE and OVEN TEMP knob to 350°R After 30-60
seconds, the oven burner will ignite and burn until the
set temperature is reached. The oven burner will con­
tinue to cycle on and off as necessary to maintain the
oven at the temperature indicated by the OVEN JEMP
knob.
The oven requires electrical power to operate. The
oven cannot be lit during a power outage, Gas will not
flow unless the glow bar is hot
If the oven is in use when a power outage occurs, the
oven burner will shut off and cannot be re-lit until
power is restored ,
(continued next page)