Sears 85951 - Manual (Page 34)

I Stirrer shield ..................................... ...............................................
The oven inside top (stirrer shield) can be gently wipdd in place or removed (or washing at the sink.
Excessive oil spatters on the inside top (stirrer shield) will make them difficult to remove, if left for
many days.
„ .
Wip>€ them with a wet paper towel especially after cooking chicken or bacon.
The stirrer shield sets in slots along the sides and in the rear of the oven and is held by three tabs in front.
Carefully pull the front edge down and forward to remove. Wash only in warm (not hot) detergent \^ter,
rin^ and wipe dry. Avoid hitting or bending the metal stirrer blade, as this could cause uneven cooking or
microwave power loss. To replace shield, slide it into the side and rear slots with cut-off at left rear comer,
and carefully fit the front edge of the shield with three tabs.
1 Exhaust filters
The two mesh exhaust filters on the hood bottom cover can be removed for washing in a sink.
The filters are held by metal springs in the center of the hood bottom cover. To remove it, place a finger
in the finger recess of the hood bottom cover and push it toward the center and pull down. Wash only in
warm detergent water, rinse and wipe dry. '
Do not use ammonia for aluminum mesh filters.
Do not run the hood fan without the filters.
34