Sears OVERLOCK 385. 564180 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2. PREPARE YOUR
machíne
FOR SEWING
(3)
Insert the thread between tension discs from
the right. Then pull both sides of thread.
Turn the hand wheel toward you to bring
needle bar to its highest position, then pass
the thread through right needle thread
guide and thread take-up leverthread guide.
(e) Pass the thread through the thread guide sliding
the thread from left to right.
(T) Pass through needle bar thread guide from left
to right.
@ Thread the right needle from the front to the
back and pull the thread about 10 cm (4")
from the eye of the needle to the back under
the foot.
NOTE; Needle may be easier to thread if you
remove presser foot {See page 27) and
lower knife (See page 29).
15