Sears 113242502 - Manual (Page 16)

10
REMOVING AMD INSTALLING SAW8LADE
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF” AND REMOVE PLUG FROM POWER SOURCE
OUTLET
BEFORE REMOVING OR INSTALLING
SAWBLADE.
A„ Remove insert,
B. Place ARBOR wrench on flat surfaces of saw
ARBOR . . ARBOR NUT wrench on nut ,.
position wrenches as shown , .hold your hands
well above blade
C. With ARBOR wrench against table, PULL ARBOR
NUT wrench FOREWARD to LOOSEN nut
D TIGHTEN nut HOLD ARBOR wrench
against rear of table , P U S H ARBOR NUT
wrench toward rear,
NOTE: When installing the blade . , . make sure the
teeth are pointing toward the front of the saw .....................
and that the blade and collars are clean, and free
from any burrs
The HOLLOW side of the collars must be against
the blade
Always tighten the arbor nut securely.
To replace insert.
Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keysloi in insert will drop over screw. Tighten screw.
Do not tighten screw to the poirst where ¡t will deflect
the insert
FLAT SURFACI5 COLLAR
ARBOR NUT
TEETH POINTING TO
FRONT OF SAW
n EXACT-I-CUT
The "yellow" plastic disc imbedded in the table in front
of the sawblade. is provided for marking the location of
the "sawcut" on the workpiece,
A„ Check disc ,, - if it is above table surface, place a
piece of hardwood on top of it and tap it down,
B, With blade 90° (square to table) cut off a piece of
wood
C. Pull miter gauge back until wood is over disc. Using
very sharp pencil, mark a line on disc,.
D With miter gauge in right hand groove, follow same
procedure and mark another line on disc
E- These lines indicate the "path" of the out (kerf)
made by the sawblade..
F. When cutting the workpiece, line up mark on
workpiece with line on disc
16