Sears 113242502 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CHECKING BLADE SQUARENESS TO TABLE

L Loosen ELEVATION LOCK by pulling KNOB forward

2, Turn ELEVATION handwheel clockwise until blade is

as high up as it will go.

IMPORTANT:

BLADE

must

be

SQUARE

!90®}

to

TABLE, in order to ALIGN rip fence-

3. ' Check for BLADE SQUARENESS ,, . if blade is not

square to table, adjust it at this time.

NOTE: The combination square must be "true" - see
start of "Unpacking and Checking Contents" section on
page 6 for checking method

Refer to "BLADE TILT, OR SQUARENESS OF BLADE

TO TABLE" adjustments on page 24

MAKE SURE SQUARE

!S

NOT

TOUCHING

TIP OF TOOTH

TILT CLAMP KNOe

ELEVATION

HANDWHEEL

TILT CRANK

Itï^l

r"Ì7

ELEVATION LOCK KNOB

SAWBLADE PARALLELISM

The sawblade must be paraliel to the miter gauge slots and
the rip fence in order to prevent heeling. To check for
parallelism:

1. Raisa blade all the way up .

2- Mark an "x" on one of the teeth which is SET fbent) to

the LEFT.

3.

Place the head of a combination square in the

GROOVE , . , adjust blade of square so that it just
touches the tip of the MARKED tooth

4.

Move square to REAR, rotate blade to sea if MARKED

tooth again touches blade of square

5.

If tooth touches square the same amount at FRONT

and REAR . . sawblade is PARALLEL to MiTER
GAUGE GROOVE

If tooth does not touch front and rear, adjust immediately

SAWBLADE TO MITER GAUGE GROOVE/

ATTACHING AND ASSEMBLING TABLE EXTENSIONS

1. From among the loose parts find the following

hardware.

4 Corner Support Brackets
4 Corner Stiffener Brackets

16 Truss Hd Screws 1/4-20 x 1
16 Ext Lockwashsrs 1/4

16 Hex Nut 1/4-20

8 Hex Hd. Screws 5/16-18 x 1-1/4
8 Ext. Lockwasher 5/16
8 Hex Nut 5/16-18
8 Flat Washer 11/32

Assemble brackets with hardware listed above as shown,

Insert 5/15-18 x T1/4 in. long screws through holes in
EXTENSION then through table. Install flat washer,

iockwashers and screw on the nuts . , , DO NOT

TIGHTEN

Align front edp of extension with front edge of saw table.

Pull Extension UPWARDS above table surface . ,
SLIGHTLY TIGHTEN SCREWS using 1/2 in, wrench.

Using small block of hardwood and hammer, tap extension

DOWNWARDS at front, center Se rear, until it is EVEN
with table surface , TIGHTEN SCREWS.

Advertising