SINGER W8418 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
15
*JUe
The zipper foot can be readily adjusted to either the right or left side of the slide fastener.
Loosen the screw "A” (Fig. 24a & 24b) and slide the foot into desired position. Adjust the needle
position as required to make the stitching close to the zipper teeth.
Needle plate should be in zig-zag sewing position and use zig-zag presser foot, so that needle
position can be changed freely.
*7a MaJm 3o^d*4if udiU
Cut a true bias strip of fabric wide enough to go over the cord and allow for a seam, usually
1” to 2” depending on size of the cord. Place cord inside the bias and place it under the focA so
that the seam edges are to the left. Stitdi the fabric as close as possible to the cord without
catching it.
Gently stretch the bias as you sew (Fig. 24c).