Maytag CWE5800 - Manual (Page 16)

MAINTENANCE
Light Replacement
Before replacing light bulb, disconnect power
to oven. Be sure bulb is cool. Do not touch a hot
bulb with a damp cloth as the bulb may break.
Use a diy pot holder to prevent possible harm to
hands. If bulb should break, use a pot holder to
protect hands and very carefully remove bulb. If
bulb breaks at base, have a service technician
remove bulb.
Oven light bulb is located on back oven wall.
Replace with a 40 watt appliance bulb. Restore
power to oven. Reset clock.
Note for Self-Clean Ovens:
Remove 4 screws and plates as illustrated below.
Use care when removing gasket, it may tear.
Replace only with a 40 watt appliance bulb.
Reconnect power to oven and reset clock.
Removable Oven Door
To remove door:
1. Open door to the broil stop position (open
about 4-6 inches).
2. Grasp the sides of the door at the middle of
the door. Slowly hft door straight up.
CAUTION:
Hinge arms are spring mounted and will slam
shut against the oven if accidentally hit. Never
place hand or fingers between the hinges
and the front oven frame. You could be
injured if hinge snaps back.
Do not attempt to open or close door until door
is completely seated on hinge arms. Never turn
on oven unless door is properly in place. When
baking, be sure door is completely closed.
Baking results will be affected if door is not
securely closed.
3. As you hft the door up, very slightly open
door by pulling door toward you. Check to be
sure latches swing down into the notches on
the hinge arms.
To replace door:
1. Grasp sides of door and align slots in door vUth
hinge arms.
2. Very slightly pull door to a more open
position as you slide the door down onto the
hinge arms. The shding action of the door will
disengage the latches on the hinge arms.
3. Gently push the door downward until the door
rests evenly on the hinges. Close door.
PAGE 14