Explanation of fault codes, During normal oven cooking, During a self-clean cycle – Maytag CWE5800 User Manual
Page 18: Service information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE INFORMATION
Before Calling a Service Technician, Check the Following
Elements Fail to Turn on or Heat Food Properly
Check circuit breakers or fuse box for tripped circuit
breakers of blown fuses. • Is element defective?
Have service technician replace.
Food Not Baking Satisfactorily
Are your racks properly in place and in correct
position for what you are baking? • Is your oven
level? • Are you using the proper pan? • Is it
bright, not soiled or dark colored? • Have you used
foil incorrectly? • Are you using standard
measuring utensils? • Did you preheat if
recommended?
Oven Does Not Operate
Was the automatic cooking feature correctly set?
• See page 6. • Is the oven disconnected from the
electrical power? • Was the oven control properly
set.
Oven Light Does Not Work
Is your bulb loose or burned out? • Is oven
connected to power?
Need Service, Accessories or Parts?
When your oven requires service or replacement
parts, contact your Dealer or Authorized Service
Agency. • Consult the Yellow Pages in your
telephone directory under ranges for the service
center nearest you. • Be sure to include your name,
address, and phone number, along with the model
and serial number of the appliance. (See inside front
cover for location of your model and serial numbers).
Explanation of Fault Codes
Your appliance is equipped with an electronic
control featuring built-in, self-diagnostic
software. This software continuously monitors the
control to insure safe and proper operation. If the
software should detect a questionable situation, a
FAULT CODE (F plus a number) will appear in
the display and continuous beeps may sound.
A fault code indicates that there may be a
functional error. As a safety precaution, the
control will automatically cancel the program.
During Normal Oven Cooking
If a fault code appears in the display and
continuous beeps sound, press the CANCEL
pad. Then, reprogram the cooking operation.
If the fault code reappears in the display, call an
authorized servicer. Do not use the oven until the
control has been serviced. The cooktop can be
used.
During a Self-Clean Cycle
If the oven is heavily soiled, excessive smoke and
flaring may result in a fault code. If this occurs,
press the CANCEL pad and allow the oven to
cool for an hour. Then, reprogram the oven for
the clean cycle.
If the fault code reappears in the display, call an
authorized servicer. Do not use the oven until the
control has been serviced. The cooktop can be
used.
PAGE 16