SINGER W1563 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

15

To Change Needle Plate —

Be sure Presser Foot is UP and needle at top position.

Raise hinged cover plate (attached to needle plate) and
leave UP. Carefolly remove screws holding needle plate--
and gripping the raised cover plate slide entire assembly

off machine. Set Stitch WIDTH Lever at 0.
Turn assembly over - - under side upward - - holding needle

plate in one hand, hinged cover plate in the other. Notice
that two small pins - - one at each side of cover plate - - fit
into grooves at each end of assembly. One pin is under

spring-hinge at one end--the other pin is unobstructed. Lift
that pin out of groove - - then the other pin can be freed as

the tongue on cover plate is separated from the spring latch on needle plate. Just reverse
the entire procedгlre to attach another type of needle plate to the hinged cover plate and re­
install the changed assembly on machine.

CAUTION - - After Changing A Needle Plate or Presser Foot Always Turn

Machine Wheel by Hand While Needle Goes Down and Comes Back Up.

Such

a

Production Avoids Breaking Needle and Damaging Machine.

- To Change Presser Foot

Be sure Presser Foot and needle are both UP. Loosen thrunb screw A with
fingers or screw driver xintil Presser Foot slips down and off. To replace
with another foot merely reverse the procedure. After changing a foot

always hand-turn machine carefully to be sure needle does not strike foot.

Advertising