Press start – Maytag MD3000 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Note: The dial can be turned in either direction to select a cycle. Once started, the dial
will not advance at a specific rate during the IntelliDry cycles. At first the dial may not
advance at all. Toward the end of the cycle (when the load begins to dry) the dial will
advance at a more regular rate and much more quickly. This is normal operation.
IntelliDry REGULAR automatically senses the moisture
in the load and shuts off when the selected dryness level
is reached. This cycle is designed for loads such as tow
els, underwear, t-shirts, jeans, etc. Set the control to the
desired dryness level (more dry - less dry). The trian
gle symbol. A, between more dry and less dry is the
initial preferred setting for the majority of loads.
/ LESS DRY
WRINKLE RELEASE DAMP DRY
• ^ ^
Push this button to start the dryer. The dryer door must
be shut for the dryer to operate. If the door is opened
during the cycle, the start button must be pushed again
to resume the cycle once the door is closed.
END OF CYCLE CHIME
When the cycle is complete, an audible chime will
sound several times. If the Press Care option has been
selected, the audible chime will sound intermittently
during the cool down portion of Press Care.
TIME DRY/AIR FLUFF may be
selected for any load if the
^ IntelliDry sensor system is not
»* desired. Set the control to the
desired number of minutes.
DAMP DRY is designed to “par
tially” dry items. It provides
, approximately 20 minutes of
heated tumbling and 5 minutes of
cool down tumbling without
release wrinkles from items that
are clean and dry but slightly
wrinkled, such as from a crowd
ed closet or suitcase or from sit
ting in the dryer too long after
the end of the cycle. It provides'
10 minutes of heated tumbling
and 5 minutes of cool down tum
bling without heat.