Section 5 one-step buttonholing, Fastening the buttonhole attachment, Setting the length of buttonhole – SINGER 9134 User Manual
Page 36: One-step buttonholing
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 5
ONE-STEP BUTTONHOLING
Your machine automatically makes a buttonhole to the size of your button in one,
easy step You never need to move the fabric or reposition the needle.
Always make a practice buttonhole on a
sample of your fabric.
Be sure bobbin contains enough thread.
reach areas, convert machine bed to
free arm sewing.
Mark buttonhole position on fabric as
indicated in pattern.
RECOMMENDED SETTINGS
Stitch Selection:
Buttonhole Stitch
Stitch Width:
. I 11 1
Stitch Length:
4
Foot: Buttonhole Attachment (L)
Needle Plate:
General Purpose (A)
Fastening the Buttonhole Attachment
•
Remove presser foot from shank.
• Place buttonhole attachment behind
shank and guide it forward.
• Center pin (1) in attachment under
shank, and lower presser foot lifter.
• Press presser foot screw down firmly
until shank snaps Into place.
Setting the Length of Buttonhole
• Open button clamp (2) and place but
ton on carrier (3).
• Slide clamp (2) back to hold button in
place.
• Raise foot lifter and draw needle thread
(A) and bobbin thread (B) between upper
(4) and lower (5) plates of button attach
ment, and to the back of machine.
Place fabric between upper and lower
plates.
Center 3 red guidelines (6) of attach
ment around beginning line of button
hole.
Lower presser foot lifter.
Push foot from back of button carrier
(7) toward you to insure proper button
hole length.