SINGER 12K Family User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ATTACHMENTS
THE ADJUSTABLE BINDER.
Adjust the binder to the desired width of binding and fix it firml
5
^
to the machine with the thumb screw. Place the end of the binding
over the feed points, and its edges under the clips, then insert the
fabric between the clips, and guide it against the binder. If the
sewing is not on the edge of the binding, loosen tlie screw and move
the binder a little to the right or left until it is in the correct position.
The under clip may be adjusted to fold the binding wider on the
under than on the upper side of the work.
THE BRAIDER.
Attach the braider to the
presser bar, pass the braid
through the eye at the top of
the arm, then take a short
piece of thread and pass the
ends through the slot in the
braider, forming a loop. Place
the end of the braid into the
loop, and drawing the thread
through the slot, the braid will
pass through with it. (Or pass
the braid through by pushing
the end with the point of a
needle.) Stamp or trace the
design on the fabric, and guide
it as required.