SINGER 12K Family User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

8

THE CORDER.

é,

Attach the corder foot to the presser bar, pass the cord into the eye of the

guide, which is held in the left hand between the folds of the fabric with its

end opposite the first groove in the foot. In placing each succeeding cord,

guide the fabric with the last cord sewn in the second groove of the foot. In
Cording, always turn a square corner while the needle rests in the fabric.

THE EMBROIDERING ATTACHMENT.

Remove the presser foot, raise the needle bar to its highest point and take

out the lower screw of the face plate. Place the attachment on the edge of the

face

plate

nearest

you,

with the fork of its driving
rod under the slack thread

])in (13). In.sert the long
screw

(supplied

with

the

attachment)

through

the

bracket arm into the lower
screw

hole

of

the

face

plate, keeping the attach­
ment close to, and level
with, the top of the head,
and tighten securely.

The reel bracket is now

hooked around the tension
screw, and also screwed to
the top of the embroiderer.
Attach

the

embroidering

presser

foot,

turn

the

balance wheel slowly, and
see that the levers pass
each other, clearing both

the needle and the presser foot. The reels are kept on the reel pins by an
clastic band. Both threads come off on the left side of the reel and pass
through the tension springs on the levers. The left lever is threaded at the
point from the inside, and the right lever from the outside, that is, towards
the needle. The tw'o threads afterwards pass under the presser foot.

Advertising