Problem and remedies – SINGER W310 User Manual

Page 37

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

PROBLEM AND REMEDIES

Trmible

Prd^able Cause

Remedies

The machine sticks

Thread or lint in the shuttle
hook.

Clean and oil the machine and the shuttle
area (see page 341.

Skipped stitches

Bent needle

Replace with new needle (see page 8).

Needle placed incorrectly
in the clamp.

Fit the needle correctly (see page 8i.

Too fine a needle for the
thread being used.

Replace the needle or thread so that they

are correctly matched (see page 7i.

Too stretchy fabric.

Place a piece of paper beneath the fabric,
or use the Ball Point Needle.

Irregular stitches

Upper thread tension too
loose.

Tighten the upper tension

Incorrect threading

See threading instructions, page 11.

Bobbin not wound evenly.

Adjust the bobbin winder (see page 101.

Uneven stitches

Material is being held back

or pulled.

Avoid pulling or holding the material just

guide it.

Upper thread tension not

tight enough.

Increase the tension.

Poor quality thread.

Try a different thread.

Needle too fine for the

thread being used.

See the needle and thread chart, page 7.

Upper thread breaks

Incorrect threading.

Refer to the threading instructions on
page 11 and rethread the machine.

Tension too tight.

Loosen the upper thread tension (see

page I5i.

Sewing is started with the
take-up lever in the wrong
position.

Always start sewing with the take-up
lever in its highest position.

Needle fitted incorrectly.

Refer to the needle fitting instructions

on page 8.

Eye of the needle bent or

too sharp.

Try a new needle.

Bent or blunt needle.

Throw away all blunt or bent needles and
replace with new needles.

------------------

Material puckers

Tensions too tight.

See tension adjustment recommendations
on page 15.

Dull needle.

Change the needle.

Stitch length too long.

Reduce the stitch length.

Machine is noisy

and material is not
fed when stretch
stitches are sewn.

Stitch length control is set

at other than the if; mark.

Set stitch length control at the jfc mark.

Incorrect feeding.

Lint in the feed dog.

Remove the needle plate and clean lint
from the feed dog.

35

Advertising