SINGER 14U11 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(3) Thread the overedge needle thread in the order ® to (7) (green mark).
Threading of needle eye (7) becomes easier when the movable knife is set at the nonoperating position
(See figure on page 18 for movable knife non-operating position).
Wind thread around thread
guide when threading (2) as
shown in figure below.
Tension
discs
While holding thread with finger, pass it
between the tension discs and pull thread
down to make certain it is properly located
in between the tension discs.
Use tweezer provided in the accessory set when
threading looper thread hole (7) .
• Draw about 5cm (2 inches) of thread from the
looper thread hole.