SINGER 14U11 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(5) Check to see that thread tension dials are properly threaded (especially needle thread).
When needle thread is not correctly threaded between the tension discs, it will lie loose on the underside
of the material as shown in figure.
• How to change thread
The thread is pre-set at the factory
before shipment.
When you wish to change the thread
with a different thread, the following
steps will make the changing con
venient.
(1) Cut the thread near the spool and
tie the end to the thread you wish
to change to as shown in figure at
right.
(2) Raise presser foot.
(3)
Turn the tension dials down
toward the minus (-) sign until
the dial stops and draw the thread
out so that the tie knot of the
threads extend about 5cm (2
inches) from the presser foot.
(4)
When drawing needle thread
through the needle eye, stop the
tie knot before the needle eye, cut
the thread and pass it through the
needle eye.
0
10