SINGER WRotary (Book 10) User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hemming
We furnish with each machine five
assorted widths of hemmers. Select
the width desired and substitute it for
the presser-foot. Take the cloth in
both hands, the right hand in front
of the hemmer and the left behind.
Place the edge of the cloth in the hem-
mer drawing it back and forth until the hem is formed, stopping with
the end under the needle. Drop presser-foot and commence to sew
Guide the cloth so as to keep the hemmer full. To change stitching
near or far from edge, loosen thumb screw and move hemmer to
right or left as desired and tighten screw.
■ r
Binding
Remove the presser-foot and sub
stitute the binder. Cut the binding yi
inch wide (on the bias if convenient).
Pass the binding through the scrolls
\ of the binder and under the presser-
foot. Place the edge of the goods to
be bound between the scrolls of the
binder, drop presser-foot, guide the
cloth with the left hand, and let the binding glide easily through
the fingers of the right. To change the stitching near or far from the
edge, move binder lug A to right or left as desired.
Under-Braider
Substitute the under-braider foot
(which is found in the box of attach
ments) for the regular presser-foot.
Place under - braider on machine
same as the shirring plate; draw the
braid under and through the tube
and a httle past the needle. The
pattern to be braided should be
stamped on the wrong side of the cloth. Place the goods under the
presser-foot same as in regular sewing, following pattern carefully.
This stitches the braid on the cloth from the underside.
19