To remove bobbin case from shuttle, To remove shuttle from shuttle race – SINGER WRotary (Book 10) User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REMOVE BOBBIN CASE
FROM SHUTTLE
Raise the take-up to its highest
point. With the thumb and second
finger of left hand clasp bobbin case
as shown in cut, then lift latch
S
with the third finger, when bobbin
case may be readily withdrawn
from shuttle
F.
See page 5,
TO REMOVE SHUTTLE FROM SHUTTLE RACE
First remove the bobbin case. Turn the machine back on its
hinges, then turn the machine in the same direction as in sewing
until the point of the needle just enters the needle plate hole; push
on rear end of latch
G
and at the same time pull shuttle race cover
away from shuttle and toward latch
G
from under pin
H
; the shut
tle can now be removed.
When shuttle has been removed from race be sure to clean both,
and oil the race slightly before replacing. Occasionally oil slightly
in hole on race cap marked
V
above and pin
W
in shuttle, see page
5 fig. 9.
4