SINGER W510 - Manual (Page 11)

(V. PREPARING r,-ACi-
21
WINDING THE BOBBIN
Disengage the hand wheel by holding it
tightly with your left hand and turning
the coupling wheel toward you with your
right hand (Fig. 21). Place the spool on
spool pin (A) , leaving about one foot of
thread free. Lead the thread around the
guide (B) on the back of the machine and
around the bobbin winder tension disc
(C), then thread guide (D) as illustrated
(Fig. 22), and run the end of thread
through a hole on the rim of bobbin.
Place the bobbin on the spindle and push
the bobbin winder to the right. Hold the
thread end securely and run the machine
slowly. Bobbin will stop turning when
filled. Cut thread and push bobbin
winder to the left. Remove bobbin from
spindle. Tighten the coupling wheel by
turning it away from you as you hold the
hand wheel in place. The needle should
now move when you turn the hand wheel.
Note: If the bobbin is winding unevenly,
adjust bobbin Winder threed guide
up or down as needed.
22