Maytag T1 - Manual (Page 21)

Oven Light
A
CAUTIONS:
Disconnect power to range before replacing light bulb.
Use a dry potholder to prevent possible harm to hands
when replacing bulb.
Be sure bulb is cool before touching bulb.
Do not touch hot bulb with adamp cloth as this may cause
the bulb to break.
To replace oven light bulb:
1. When oven is cool, hold bulb cover in place, then slide wire
retainer off cover. NOTE: Bulb cover will fall if not held in
place while removing wire
retainer.
BULB COVER
2. Remove bulb cover and
light bulb.
3. Replace with a 40 watt
appliance bulb.
4. Replace bulb coverand
secure with wire retainer.
5. Reconnect power to range. Reset clock.
Leveling Legs
A
CAUTION:
Be sure the anti-tip bracket secures one of the rear
leveling legs to the floor to prevent the range from
accidentally tipping.
The range should be leveled when installed. If the
range is not level, turn the plastic leveling legs,
located at each comer of the range, until range
is level.
ANTl-TtP BRACKET
Storage Drawer
A, CAUTION:
Do not store plastic, paper products, food or
flammable materials in this drawer. The drawer
may become too warm for these items when the
oven is in use.
The storage drawer can be removed to allow you to
clean under the range,
To remove:
1. Empty drawer and pull out to the first stop position.
2. Lift up the front of the drawer.
3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
To replace:
1. Fit the ends of the drawer glides into the rails in the
range.
2. Lift up front of drawer and gently push in to the first
stop position.
3. Lift drawer up agai n and push until drawer is closed.
Convenience Outlet
(Canadian models only)
The convenience outlet is
located on the lower left
side of the backguard. It is
useful for small appliances
such as waffle irons.
-
.......
CIRCUIT BREAKER
SWITCH
Û
LEVELING LEG
When using the outlet be
sure the appliance cord does not rest on or near the
surface element. If the surface element is turned on, the
cord and outlet will be damaged.
The convenience outlet circuit breaker may trip if the
small appliance plugged into it exceeds 10 amps. To
reset the circuit breaker, press the switch located on the
lower edge of the backguard. (See illustration.)
20