SINGER W312 Old - Manual (Page 32)

Length: Symtooi
D
Width: 2
Feed Dog: DOWNI-UP-DOWN-UP^DOWN
Pressure: Puli
Foot: Buttonhole Foot
TURN-AROUND BUTTONHOLE
1. Place materia! under presser foot to sew the
top or low end of marked buttonhole. Push
left button of feed dog height control
all the way down, hold creative embroidery
control at its right end position, take few
stitches to bartack the end of marked button­
hole,
2. Push right button of feed dog height control
all the way down, release creative embroidery
control, set stitch width control at 2. then,
sew down the left edge of marked button­
hole and finish stitching with needle in
fabric at the right side of stitches. Set feed
dog at down position.
3. Lift presser foot and pivot the fabric around,
then lower presser foot and take one stitch to
left turning hand wheel by hand.
4. Pushing creative embroidery control to right,
take few stitches to bartack another end of
marked buttonhole,
5. Up feed dog to high position and sew down
other edge of marked buttonhole.
6. Lock thread by stitching a few stitches at
0 width and down position feed dog height.
Cut center open space of buttonhole carefully
so as not to cut into the stitches, as illustrated
previously.
Length; Symbol f|
Width 1 - 2
reedOog- DOWM-UP-DOWN-UP-DOWN
Pressure Full
Foot Bunonhole Foot
CORDED BUTTONHOLE
Cording gives a reinforced raised buttonhole. It is
excellent for use on bulky, woven fabric, or knits
in which the stitching often gets buried and
makes cutting difficult. On knits, a corded
buttonhole will help keep the fabric from
stretching out of shape.
Choose a heavy cotton crochet thread or
buttonhole twist to use for the cording. Proceed
as for the turn-around buttonhole having cord
the under the presser foot in such a way that
the zigzag stitch covers the cord.
At the compietion of the buttonhole snip the
excess cord dose to the bartack on woven
fabrics. For knitted garments, always null the
cords to the wrong side by using a darning needle
or needle threader, and knot the cord ends
before clipping.
32