SINGER W217 - Manual (Page 7)

4.
6
.
Turn the balance wheel
is at its highest point
THREADING THE MACHINE
(20) by bond toword you until the needle (K)
(22) and pass the thread
S'), down between the tension
possing over
Place a spool of thread on the spool pm
through the upper thread guides (A) and (
disc (C') from the Right to Left.
Now bring the threod up, pulling up the check spring
threod guide (D'l and in the thread guide (F'),
Carry the thread up to and into the eye of the threod take-up lever
RIGHT to LEFT and down through the threod guides fH"), (I)
and f J'). , I j
Now'thread the needle (Ki from the LEFT to RIGHT ond drew the threod
out about six inches.
Holding end of the thread, turn the bolonce wheel toward you until the
needle moves down ond up again, thus catching the under thread.
When the take-up lever (4) is ot its highest point, puli the end of the
needle threod you are hold­
ing and the under thread
will be brought up with it
through the needle hole in
■the needle plate ( 1 5 ) , os
shown (Fig. 12)
8. Lay both ends of threod
under ond to the bock of
the presser foot ( 1 2 ) , os
shown in Fig. 13.
Fig. 12
Fig. 13
8
-
STRAIGHT STITCHING
t i l l
) f '
/
23
Fig. 14
Thread the machine. The machine wiU
ft, ,.gz ,9 d,., 123) a, I 1 > as show" F,,. 14 The
™,hes„ai
9
h,s,,.ch. .............................,h h.h.h „
0
,»
T„,„ *= hdlonc. wh. 20
t ......
he ,d,e,a, ,F. holddc. .heel .0^4,20.
„ „ ed-habl. .0 1.0 ih. ..™od on -he 0 I. 9
::eG:.:rrr:rd:.i.. . h . n . . d i . o n d 00™ „ .o
breok. The machine feeds without ossisionce.
NOTE f
. , 1 ,» mnrhine without motenoi under the presser foot.
Never operate .he moc „„rhine will lock ond connot
,S His IS no. strictly odhered to, your moch.ne will o
be operoted until the thread is cleoned out o* _______________
TO REMOVE THE WORK
Stop stitching. Turn the bolonce wheel whh He nght ^
you .0 roise the threod toke up lever (4 o s ^ e P
threods.