Attaching blindstitch guide, Attaching feed cover – SINGER 484.1544180 (Sold at Sears) User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching Feed Cover
For darning and free-motion embroidery, the
feed cover prevents the feed from moving the
material. Attach it as follows:
^
Raise needle and presser foot, and open slide
plate.
^
Slide feed cover on top of needle plate, press
ing tabs (1) and (2) into holes in needle plate.
Then, close slide plate.
^
To remove, open slide plate. Lift front edge
of cover (3) and pull it away.
The optional darning and embroidery foot
(381459-001), available from Sears parts depart
ment, may be used.
If operator prefers to do these operations by
removing presser foot and shank entirely from
machine, be sure presser bar is lowered to main
tain proper thread tension.
Attaching Blindstitch Guide
^
Raise presser foot and loosen presser foot
screw with a coin.
^
Slip blindstitch hem guide between screw
and presser foot shank.
^
Be sure underside of the guide (5) clears the
slide plate and front of foot.
^
Tighten screw (4) with the coin.