SINGER W1044 - Manual (Page 21)

22. ZIPPER SEWING
Release the thumb screw on rear side of foot. Lower needle into the
side notch of the foot and check position of the foot to avoide needle
strike the foot. Fasten thumb screw to the lock make sure that the foot
into position. , . , , I
Fold edge of the material by %" and place zipper under the folded portion
of the material where you wish to attach the zipper.
Stretch close to the edge of the zipper foot along zipper teeth.
To sew on the opposite site of the zipper, loosen thumb screw and slide
the foot over and sew the same way.
23. FELLING
Use the hemmer foot for doing felling and proceed in the following manner:
1. Lay twa pieces of cloth one on top of the other with their RIGHT sides facing
each other. The right edge of the bottom piece must extend about /.¿inch beyond
' the right edge of the top piece. See Fig. 26-
2. Sew both pieces of cloth together using the hemmer foot like a regular presser
foot. Use the right edge of long toe of hemmer foot to guide the bottom piece
of material while the left edge of the same toe serves as a gu i de for the top piece
of material. Fig. 26 shows this detail.
3. Open and spread out material and put back on machine right sides downward.
Make sewn edges of material stand up.
Fold over the edges to the left and insert them into the scroll of the hemmer foot.
Sew as you would do ordinary hemming. Use left edge of long toe of hemmer
foot as guide, having original seam run alongside of it (Fig. 27'
^ 2 0 -^