Maintenance – Ryobi CS30 RY30923 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MAINTENANCE

MAINTENANCE

STRING REPLACEMENT

See Figures 26 - 28.

u Stop the engine and disconnect the spark plug wire. Hoid

the string head and turn the spooi retainer ciockwise to

remove.

■ Remove the spooi from the string head.

NOTE: Keep the spring attached to the spooi. Remove
any oid string remaining on the spool.

■ Cut one piece of trimmer iine 18 ft. iong.

■ Find themiddleofthestringsection.Loopthestring around

the hook in the center of the spool. Carefully wind the

string in the direction indicated on the top of the spool.

Nearing the end of the string, siide one end of the string
into each siot of the spooi. Do not overfili.

■ Replace the spool and the spool retainer. Refer to Spool

Replacement earlier in this manual.

CLEANING

THE

EXHAUST

PORT AND

MUFFLER

NOTE: Depending on the type of fuel used, the type and
amount of oil used, and/or your operating conditions, the
exhaust port, muffier, and/or spark arrestor screen may
become blocked with carbon deposits, if you notice a

power loss with your gas powered tooi, you may need to
remove these deposits to restore performance. We highiy
recommend that oniy quaiified service technicians perform

this service.

SPARK ARRESTOR

The spark arrestor must be cieaned or replaced every 25

hours or yearly to ensure proper performance of your prod­
uct. Spark arrestors may be in different locations depending
on the model purchased. Please contact your nearest service
dealer for the location of the spark arrestor for your model.

REPLACING AND CLEANING AIR FILTER

See Figures 29 - 30.

For proper performance and long life, keep air filter clean.

■ Remove the air filter cover by pushing down on the latch

with your thumb while gently pulling on the cover.

■ Remove the air filter and clean it in warm soapy water.

Rinse and let dry completely.

■ Reinstall the air filter.

■ Replace the air filter cover by inserting the tabs on the

bottom of the cover into the slots on the air filter base;
push the cover up until it latches securely in place.

NOTE: For best performance, replace annually.

FUEL CAP

WARNING:

A leaking fuel cap is a fire hazard and must be replaced

immediately.

20

The fuel cap contains a non-serviceable filter and a check
valve. A clogged fuel filter will cause poor engine perfor­
mance. If performance improves when the fuel cap is loos­
ened, check valve may be faulty or filter clogged. Replace
fuel cap if required.

SPARK PLUG REPLACEMENT

This engine uses a Champion RCJ-6Y or NGK BPMR7A
spark plug with .025 in. electrode gap. Use an exact re­

placement and replace annually.

STORING THE PRODUCT

■ Clean all foreign material from the product. Store idle unit

indoors in a dry, well-ventilated area that is inaccessible

to children. Keep away from corrosive agents such as
garden chemicals and de-icing salts.

■ Abide by all ISO and local regulations for the safe storage

and handling of gasoline.

When storing 1 month or longer:

■ Drain all fuel from tank into a container approved for

gasoline. Run engine until it stops.

AIR FILTER COVER

AIR FILTER

COVER

Fig. 30

21

Advertising
This manual is related to the following products: