Bahery cable conneaions, Bahery compartment – Generac Power Systems 00802-3 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
BAHERY CABLE CONNEaiONS
1. Connect the battery cable from the battery post or terminal
indicated by a POSITIVE, POS or (+) to the large lug on
the starter contactor as indicated in Figure 31.
2. Connect the battery cable from the battery post indicated
by a NEGATIVE, NEG or (—) to the frame ground connec
tion (Figure 31).
NOTE: If the generator compartment is grounded to
the vehicle chassis, you need not connect a NEGA
TIVE battery cable to the frame ground on the genera
tor base. Connect the negative cable to the frame
ground of the chassis.
3. Connect cables so the connections are clean and tight.
BAHERY COMPARTMENT
Install the generator battery in its own, vented com
partment. Place the battery compartment away from
any source of heat, sparks or flame.
Provide ventilation openings in the battery compart
ment. The minimum size of openings should be 2
square inches at the top of the compartment. Mount
the battery on a strong, rigid supporting structure,
where leaks and spills of battery fluid will not cause
damage.
F i g u r e 3 1 — C o n n e c t i n g B a t t e r y C a b l e s
27
—