Assembly instructions – MTD TMO-33849A User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HEX BOLT (U)
LOCKWASHER (S)
ASSEMBLY INSTRUCTIONS
1. Remove the snow thrower, all loose parts and
hardware package from the carton.
2. Tip the snow thrower forward, so that the augers
are face down.
■ 3. Assemble the linkage arms (Ref. AE & AF) to the
housing assembly as shown in figure 4. Be sure
the linkage arms have the large notch up. Secure
with four hex bolts (U) 1/2-13 x 1.25" Lg., four
hex nuts (T) and lockwashers (S) provided.
FIGURE 4
HELPER bPRING (Z)
4. Place helper spring (Z) in position on linkage arm
assemblies. Secure with flat washers (W) and hex
bolts (V) provided in hardware pack. See figure
5. Thread bolt approximately one inch into the
spring insert. Adjustment is made in step number
26.
Tip the snow thrower back in normal position so
that is rests on linkage arms.
FIGURES
DRIFT
CUTTER
CARRIAGE BOLT
(H)
LOCK WASHER (I)
HEX NUT (J)
Assemble the drift cutters (AH) to the snow
thrower housing with four carriage bolts (H),
lockwashers (I) and hex nuts (J). See figure 6.
Heads of carriage bolts assemble from the inside
of housing.
FIGURES