MTD TMO-33849A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHUTE ASSEMBLY (Al)
NOTE
Before setting the chute assembly on
the spiral housing assembly, grease the
housing for ease of operation. See
figure 7.
7. Assemble the chute assembly (Al) to the housing
using three chute flange keepers (Y) and six hex
lock nuts (X). See figure 7.
FIGURE 7
IDLER PULLEY
FIGURES
■8. Place the 85" belt (A) in position on the idler of
the snow thrower as shown in figure 8.
NOTE
The idler bracket has three holes for
belt tension adjustment. Normally, the
idler pulley is assembled in the center
hole. If the belt is too tight to
assemble, the idler pulley may be
moved to the top hole.
PREPARING THE LAWN
TRACTOR FOR ASSEMBLY
OF SNOW THROWER
1. Remove the gas cap and place a piece of plastic
film on the gas cap to prevent gas from leaking out
of the tank.
NOTE
If unit is electric start remove the
battery.
2. Remove the spark plug wire from spark plug and
grounrd.
3. Remove the mowing deck.
4. With a piece of wire hold the front left hand deck
hanger out of the way. See figure 9.
NOTE
This hanger bracket is straight.
FIGURE 9