MTD TMO-33849A - Manual (Page 8)

HEX BOLT
(N)
FIGURE 13
1 V
.12. Pre-assemble the linkage bracket (AG) to the
idler assembly (AJ), as shown in figure 14.
Secure with hair pin cotter (E). NOTE: Slot in
linkage bracket goes to the rear.
u>vin DIM COTTFR^i^
LINKAlU EiBACKl I -tO'
FIGURE 14
IHp
CONTROL ROD
FLARVASHFI.:-; (K<^
■ 13. Assemble the other linkage bracket (AG) to the
other side of idler assembly (AJ). Secure with
hair pin cotter (E). Place flat washer (K) over
control rod. Next, place control rod up through
linkage bracket. Secure with another flat washer
(K) and hair pin cotter (E). See figure 15.
HAIR PIN COTTERS (E)
FIGURE 15