MTD TMO-33849A - Manual (Page 7)

FIGURE 10
FIGURE 11
NOTE
After removing the deck, check the
deck links. The weld pins should be
outboard. If not, change them. It is
easier to change deck links by re­
moving the transmission cover and
knob. After changing deck jinks,
reassemble the transmission cover and
knob.
Remove the second bolt on the running boards as
shown in figure 10. (Right and left hand sides).
Replace the bolts with hex bolts (N) 5/16-18 x
1.25" Lg. provided with snow thrower. Fasten
with 5/16-18" nut (Q) and lock washer (I).
Tighten with wrench.
7. Tip the lawn tractor up on its rear wheels so that
the unit rests on the back on the seat.
Remove the belt keeper and shoulder bolt at
engine pulley (if these were replaced when deck
was removed).
9. Assemble the channel supporting brackets right
and left hand to lawn tractor. See figures 12 and
13.
10. Hook thp'^!^ of channel supporting bracket right ^
hand''fAD) of oki^ pedal mounting
bracket. See figure 12.
11. Place flanged edge of channel support bracket
over hex bolt (N) (which you assembled in step 6).
Secure with lock washer (I) and hex nut (Q). See
figure 13.
FIGURE 12