Assembly, Assembly -7, Remove generator from carton – Generac 1019-3 User Manual

Page 6: Install wheel kit

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ASSEMBLY

Your generator requires some assemb y and is ready for

use after it has been praper y serviced with the
recommended oil and fuel.

If you have any problems: with the assembly of your

generator, please call the generator helpline at

1-800-270-1406.

IMPORTANT: Any attempt to run the unit before it has

been serviced with the recommended oi will result in an
engine ^ilure.

Remove Generator From Carton

1. Set carton on a rigid flat surface with “This Side Up”

arrows pointing upvrard.

2.

Carefully open top flaps of shipping carton. Review
"Cold Weather Operation” on page 10,

3. Cut down corners at one end of carton from top tx>

bottom and lay that side of carton down flat

4.

Remove all packing materia, carton fillers, etc,

5. Remove the generator from the shipping carron.

Install Wheel Kit

The wheel kit is designed to greaty improve the portability
of your generator.

NOTE; Whee kit is not intended for over-the-road use.

You will need a socket wrench with 1/2” or 13mm sockets
and a need e-nose p ier to install this kit.

Refer to Figure I and install the wheel kit as follows:

I.

2

.

3.

Place the bottom of the generator cradle on a flat,

even surfice.Temporarily place unit on blocks to ease
assembly.

Slide axle through both axle mounting bracl@ts on
cradle frame, as shown in Figure I,

Slide a whee over the axle.

NOTE; Be sure to install both whee s with the air

pressure valve on the outboard side.

4.

Place the e-ring onto the groove in the axle,You may

add the flat washer if desired.

NOTE; Use retaining pins instead of e-clip, if app icab e,

5. Place one end of the needle nose p iers on the bottom

of the ax e and the other end of the pliers on top of
the e-ring. Seat the e-ring by pressing the p iers closed.

6.

Repeat step 3 through 5 to secure second wheel.

Figure I —liistallWhccI Kit

Advertising