Generac 1019-3 - Manual (Page 7)

7500EXL Extended Life Generator
Id=lw^l=l=F±T-y
Farta DU rrodncti
7. Remove the temporary blocks.
8. Ata,di the vibration mounts to the support eg with
30mm capscrews, vrashers and lock nuts,
9. With the wheels on, you can now lift up the handle
end and attach the support leg with 20mm cap screws
and lock nuts.
ID. Check that a I fasteners are tight and the tires are inflated
to the та1ие marl®d on the tire or within 15 and 40 psi.
Check Battery / Attach Negative
Battery Wire____________________
The sealed battery on the generator is fully charged and
pre-installed except for the ne;^tive (blacic) battery cable.
To install:
1. Cut off tie wrap securing oose end of ne;^tive (b ack)
cable.
2. Remove nut and v^isher on neptive battery terminal.
3. S ide negative battery cab e over screw on ne;^tive
terminal (Figure 2),
Figure 2— Negative Battery Connection
4. Reattach washer and nut and tighten.
5. Verify that connections to battery and generatx>r are
tight and secure.
BEFORE STARTING THE
ENGINE
Add Engine Oil and Fuel___________
• Place generator on a level surface.
• Refer to engine owner’s manual and follow oil and fuel
recommendations and instructions.
CAUTION
Any attempt to crank or stai't the engine before it has
been propei'ly filled with the recommended oil will I'esult
in equipment failure.
; Refer to engine manuai for oil; and fuel fill information,.....
: Damage tol equilpmant resulting from failure to follow this
; instruetioh will void warranty.
NOTE; Check; oil often during engine break—in. Refer to
engine owner’s manual for recommendations,
NOTE: The generator assemb y rotates on a prelubricated
and sealed ball bearing that requires no additiona
lubrication for the life of the bearing.