Troy-Bilt PONY 664DM - Manual (Page 35)

Models 664D & E666M
BOLO TINES, WHEELS
NOTE 1: Custom Tilling Tines are
available for your tiller. These are
special hard-faced tines that are
thicker than standard tines.
IMPORTANT: Left and right sides of
tiller are determined by standing in
operator position and facing direc­
tion of forward travel.
REF.
No. PART
No. DESCRIPTION QTY.
REF.
No. PART
No. DESCRIPTION QTY.
1 710-3105 Hex Hd. Screw, 3/8-16x1-1/4*............ 16
_ _
GW-2475-1 Custom Tilling Bolo Tine, Left hand
2 GW-1270-2A Bolo Tine-single. Right hand tine tine (see Note 1 above)................... 8
used on left side of tiller. (Incl.
-
GW-2475-2 Custom Tilling Bolo Tine, Right hand
two ea. Refs. 1 and 3)..................... 8 tine (see Note 1 above)................... 8
3 712-0375 Hex Locknut, 3/8-16............................ 2
-
GW-10802 Custom Tilling Bolo Tine Replacement
5 710-3096 Hex Hd. Screw, 3/8-16x2, Grade 8.... 2 Set (Incl. eight ea. right hand and
7 GW-1270-1A Bolo Tine-single. Left hand tine left hand custom tines, and sixteen
used on right side of tiller. (Incl. each of Refs. 1 and 3)..................... 1
two ea. Refs. 1,9 and 10)................ 8 9 712-3017 Hex Nut, 3/8-16................................... 16
8 1902154010 Tine Holder. For left and right sides.... 2 10 736-0169 Lock Washer, 3/8................................ 16
- 1901118 Bolo Tine Replacement Set (Incl. eight 11 GW-9380 Clevis Pin, .312x1-3/4......................... 2
ea. right hand and left hand tines. 12 GW-9338 Hitch Pin.............................................. 2
and sixteen ea. Refs. 1 and 3)........ 1 13 1917487 Wheel and Tire Assembly................... 2
Specify GRADE 5 if ordering part locally.