Lexicon MX200 - Manual (Page 10)

1 . Dual Input Bargraph Meters
LEDs indicate input level for each channel.
2. Digital In LED
Indicates when the S/PDIF digital input is
selected and active.
3. Routing Button
Press this button to cycle through the four
signal routing options. For more informa-
tion about routing, see page 12.
4. Active Reverb / Effects Matrix
Indicates which effects are active at all
times. Green LED indicates active effect in
Processor 1, red LED indicates active
effect in Processor 2.
5. Tempo Button - P1
Tapping this button twice sets the Delay
Time of Processor 1. LED flashes to indi-
cate current tempo, or lights solid when
synched to MIDI.
6. Bypass Button - P1
Bypasses Processor 1. In the factory
default, this puts the processor into Bypass
mode and allows dry, unprocessed signal
to pass through to the outputs. To change
to Bypass Mute, which allows no signal
(wet or dry) to pass, see Bypass Mode
Select in the Utilities section on page 25.
7. Tempo Button - P2
Same as for Processor 1 (see #5).
8. Bypass Button - P2
Bypasses Processor 2. Red LED lights to
indicate effect is bypassed.
9. Store Button
Stores program modifications to one of the
99 User program locations. Press the
Store and Audition buttons simultaneous-
ly to access Utility functions. (See page 23
for more information.)
10. Audition Button
Plays audio samples through the proces-
sors to audition their settings. Press the
Audition and Store buttons simultaneous-
ly to access the Utility functions. (See page
23 for more information.)
11. Input Knob
Controls the input level of both Left and
Right analog inputs.
12. Mix 1 Knob
Controls the P1 Wet/Dry effects mix.
13. Mix 2 Knob
Controls the P2 Wet/Dry effects mix.
D Diiaaggrraam m -- FFrroonntt PPaanneell
1 2 3 4 5 6 7 8 9 10
11 12 13 14
15
16
17
18
19
20
21
22
23
4
* Refer to the Effects Descriptions section
for more information about parameters.