Garmin Edge 800 - Manual (Page 16)

12 Edge 800 Owner’s Manual
ANT+ Sensors
Putting on the Heart rate
Monitor
See the Edge 800 Quick Start
Manual or the accessory package for
instructions.
Pairing the Heart rate
Monitor
If you purchased a heart rate monitor
separately, you must pair it with the
Edge in order to view your heart rate
data. Before you can pair, you must put
on the heart rate monitor.
1. Turn on the Edge.
2. Bring the Edge within range (3 m)
of the heart rate monitor.
3. Select MENU > > Bike
Settings > Heart Rate > ANT+
Heart Rate.
4. Select Heart Rate Monitor > Yes.
5. Press .
When the heart rate monitor is
paired, a message appears, and
appears solid on the status page.
6. If necessary, select Rescan.
7. If necessary, customize heart rate
data fields ( page 30 ).
After you put on the heart rate monitor,
it is on standby and ready to send data.
TiP: If heart rate data does not appear
or if you have erratic heart rate data,
you may have to tighten the strap
on your chest or warm up for 5
–
10
minutes ( page 17 ).
Setting Your Heart rate Zones
The Edge uses your user profile
information from the initial setup to
determine your heart rate zones. For
the most accurate calorie data during
your ride, set your maximum heart rate,
resting heart rate, and heart rate zones.