Bowflex Xtreme 2 - Manual (Page 15)

13
Step 17 - Cable & Pulley Routing
Prepare Cables to be installed to the Lat Pulley Housing
Locate the following items:
• (2) Pulleys (already installed, shown labeled as an encircled numeral 2)
• (1) 3/8" X 4 1/2" Hex Head Bolt (installed)
• (1) 3/8" Washer (already installed)
NOTE: Connecting these Cables is much easier with a second person assisting you.
1. Remove the 3/8" X 4 1/2" Hex Head Bolt and 3/8" Washer already installed on the back of the Lat Pulley Housing.
Set aside until the end of Step 18.
2. The (2) Pulleys will slide down and out of the housing without the hex bolt holding them in place.
3. Unwrap the Right Pulley Cable on the Right Frame Rail. Thread that cable beneath and then over one (2) Lat Pulley
(following the arrows shown in Figure 17), holding the cable tightly where indicated.
4. Repeat with the Left Pulley Cable, without loosening your grip on the Right Pulley Cable.
Figure 17- Lat Pulley Housing
Grasp and hold
Cables here
Towards the Rear of
the Machine
Towards the Front
of the Machine
Right Pulley Cable
Left Pulley Cable
Lat Pulley Housing
Washer
Hex Head Bolt
NOTE: Pulleys shown are seperated
for clarity. Pulleys do NOT
come apart on your machine.