Bowflex Xtreme 2 - Manual (Page 17)

15
Step 19 - Cable &
Pulley Routing
Connect Rod Cables through the
Right (3) Floating and Lat Tower
Pulleys
Locate the following items:
• 3 & 8 Floating Pulleys
(connected unit)
• (2) Cable End Stop Balls with Core
(see Detail 19b).
Take the Right Rod Cable that you
ran through the Lat Pulley Housing
and thread that Cable through the
(3) Floating Pulley, as shown in
Figure 19.
Continue to guide that Cable up
through the (4) Pulley on the Rear
Lat Cross Bar, and then through the
(5) Pulley on the Front Lat Cross
Bar, as shown.
Finally, insert the Cable End through
the Cable End Stop Ball and then
attach the Cable Core to keep the
Cable from slipping back through
the Pulleys, as shown in Figure 19b.
NOTE:
The Cable End Stop
Ball Core should fit over the
Ferrule when installed correctly.
Rotate the Core to align it with
the groove in the Ball.
Figure 19 - Lat Tower Pulleys
Floating Pulley
Lat Tower Pulleys
Cable End Stop Ball
Right Rod Cable