Bowflex Xtreme - Manual (Page 9)

7
Assembly Guide
Step 7 Install
Slider Pulleys
Parts:
• 2 Slider Pulleys with Cable Assembly
• Main Assembly
Hardware:
• 2 Cap Screws (1/4" X 1/2")
Tools: Phillips Screw Driver
7-1 Install a Slider Pulley onto each Pulley
Arm as shown. Choose any of the four
holes to secure.
7-2 Install a cap screw into the underside
of each Pulley Arm, as shown.
Cap
Screw
Slider Pulley w/
Cable Assembly
Cap
Screw
Step 8 Secure Pulley Arms
Hardware:
• 2 Threaded Studs (1/2" X 11")
• 4 Nylock Nuts (1/2")
• 4 Washers (1/2")
Tool: Rubber Mallet
8-1 Align the two holes in the
Pulley Arms with those in the
Lower Lat Tower Assembly and
secure using threaded studs,
washers and nuts as shown.
Flat Washers
Threaded
Studs
Nylock Nuts
Nylock Nuts
Flat Washers
Slider Pulley w/
Cable Assembly