Hunter X-CORE - Manual (Page 26)

24
Easy retrieve™ program memory
The X-Core is capable of saving the preferred watering program
into memory for retrieval at a later time. This feature allows for a
quick way of resetting the controller to the original programmed
watering schedule.
to save the program into the memory
1. With the dial in the RUn position, press and hold the and
buttons for 5 seconds. The display will scroll three segments
from left to right across the display indicating the program is
being saved into memory.
2. Release the and buttons.
to retrieve a program that was previously saved into memory.
1. With the dial in the RUn position, press and hold the and
buttons for 5 seconds. The display will scroll three segments
from right to left across the display indicating the program is
being saved into memory.
2. Release the and buttons.
programmable Delay between stations
This feature allows the user to insert a delay between stations
between when one station turns off and the next one turns on.
1. Start with the dial in the RUn position.
2. Press and hold the button down while turning the dial to the
RUn tIMes position.
3. Release the button. At this point the display will show a delay
time for all stations in seconds, which will be flashing.
4. Press the or buttons to increase or decrease the delay
time between 0 and 4 hours.
5. Return the dial to the RUn position.
Clearing the Controller’s memory/resetting
the Controller
If you feel you have misprogrammed the controller, there is a
process that will reset the memory to the factory defaults and erase
all programs and data that have been entered into the controller.
1. Press and hold the button.
2. While holding the button press the RESET button for 3 sec-
onds, then release the RESET button while continuing to hold
the button.
3. Continue holding button until time is displayed (this takes
about 8 seconds).
aDVaNCED fEaTUrEs