Line 6 M9 - Manual (Page 5)

is not currently displayed simply double tap the Memory Footswitch you
would like to edit, or press and hold TAP and quickly press the MODEL
SELECT knob to scroll through active FX Units.
4. Model Select - Press in the knob to select an effect type (Delay,
Modulation, Distortion, Filter or Reverb) you want. Then turn the knob
to scroll through available effect models.
5. Parameter Knobs - Use these knobs to edit current effect settings shown
in your display. These knobs usually control the setting locations as
shown in the diagram to your left.
6. TAP - Tap your tempo on the switch a few times to set the time/speed/
tempo of all TAP enabled effects.
s
Cenes
& s
Cene
s
etup
You can run your M9 Stompbox Modeler in Scene Select Mode giving
you 6 scenes, each of which is a complete pedalboard, storing all the
settings of the A/B memories of the 3 FX Units. We’ve loaded each
scene with an example pedalboard, to get you inspired.
Select
Scene
PRESS TAP
TO CANCEL
To access your Scenes, simultaneously press 3A + Tap . Your display will
now look similar to the display shown above. The 6 Scenes are displayed
as A & B for each of the 3 FX rows. The currently active Scene is shown
in the solid circle ( FX2 Unit A in the example above). To select a differ-
ent Scene, press any of the other 5 FX Unit Footswitches. Momentary
Scene Mode is the default setting, so selecting a new scene puts you right
into a whole new pedal board where you can turn effects off and on.
Choosing Momentary or Latch Scene Modes
Simultaneously press 1B + 2B to enter setup then press
the model encoder until you see this screen:
MOMEN
1>2>3
MNL SAVE
Prefs Scenes
DSP BYP
SCENE
REL
DIM ON
POTS
Use your parameter knob (bottom center) to select between Momentary
( MOMEN SCENE ) or Latch ( LATCH SCENE ). When you are done,
simultaneously press 1B + 2B to exit setup.
Momentary Scene Mode
In Momentary Scene Mode, once you select a new Scene your display
will then return to the basic view displaying the current settings of the
first active FX Unit in your chain. You can now activate or bypass any
FX Unit if you would like. Any changes you make to the Scene will
automatically be saved, just like a traditional pedalboard setup. To select
a new Scene, simultaneously press 3A + TAP, then press any A or B
footswitch.
Latch Scene Mode
In Latch Scene Mode, the only difference is when you access your Scenes
( 3A + TAP ), the 6 Scenes remain on the display after you load a new
Scene - you won’t see FX Unit settings in the LCD.
This mode is exceptionally handy when you want to switch from one set
of multiple effects to another. You can tweak individual effects in Latch
mode by simply pressing 3A + Tap to toggle out of scene mode. After you
are done tweaking just press 3A + Tap again.
Scene Save
To save your current set of FX Units settings to a scene or to copy your
currently loaded Scene, press and hold 3A + TAP until the following
screen appears:
Save
To:
PRESS TAP
TO CANCEL
Now press the footswitch of the desired location you’d like to save your
scene to. Your display should now read “ Save Completed ” for 2 seconds
then return to normal operation for the mode your Scenes are set to.