Line 6 M9 - Manual (Page 7)

required. It’s just as if you were adjusting different physical stompboxes,
each of which would still have the last knob settings you made to it. The
same is true as you switch scenes, swapping one virtual pedalboard for
another: when you come back to a previously used scene, it loads with
all the last adjustments you made to it.
If you prefer that scenes not remember your last adjustments, simultane-
ously press 1B + 2B to enter setup, then press the model encoder until
you see this screen:
MOMEN
1>2>3
MNL SAVE
Prefs Scenes
DSP BYP
SCENE
REL
DIM ON
POTS
Now set the Scenes parameter to MNL SAVE (Manual Save) instead
of AUTOSAVE . You will then need to use the scene setup mode any
time you want to manually force a “save” of current settings to a scene:
Simultaneously press and hold TAP + 3A then select and hold on the
same memory location you are currently on to “save”. Display will say
“ Save Completed ”.
Tap Tempo
Tap tempo is available for all Delay effects, most MOD effects, and some
Filter effects. For Delay and MOD effects turn the second top row knob
or for Filters turn the first bottom row knob of the FX Unit all the way
to max, and you’ll switch between tap tempo and regular control modes.
Once you’re in Tap tempo control mode, turn the knob to select one of
the available note values. Tap 2 or more times on the TAP switch, and
all the effects set to tap tempo control will change their time/speed/
tempo to match the tempo you tapped. To end tap tempo operation
for an effect, turn the knob to max again. NOTE : Parameters set to tap
tempo control are NOT affected by expression pedal operation.
Tuning
Simultaneously press 2B + 3B to enter Tuner Mode. All effects processing
and looping will be bypassed. Use your lower left parameter knob to set
your reference frequency. Use the lower right parameter knob to select
either “ BYPASS AUDIO ” or “ MUTE AUDIO ” for silent operation.
50 50
b #
MUTE
AUDIO
440
REF
E
Mono / Stereo Operation
Some models (like Stereo Delay) provide stereo operation. When run
before a mono model (like a distortion), the signal will collapse to mono
as it feeds the mono effect, and will then be passed on in mono to the
next effect or outputs.
Effect Copy
An effect can be copied to any other memory location within a scene.
For example you can copy your effect in memory location FX Unit 1A
to FX Unit 3B . To begin, select the memory location you would like to
copy (the effect must be on and currently showing its parameters in your
display). Press and hold the Model Select knob. Your display should read
“ Copy Effect: Select Destination ”. Press the memory footswitch for the
location you want to copy to. Your display now reads “ Copy Completed ”.
Your copy is now stored in both the original and new location.
a
DDitionaL
s
etup
Access all the setup screens by simultaneously pressing 1B + 2B. Then
press the MODEL SELECT knob to scroll through the different setup
pages.
MOMEN
1>2>3
MNL SAVE
Prefs Scenes
DSP BYP
SCENE
REL
DIM ON
POTS
True Bypass / DSP Bypass
Choose True Bypass when you want to remove the M9 Stomp Modeler
from your signal path when all FX Units, Looper and Tuner are not in