Line 6 M9 - Manual (Page 8)

use. When choosing DSP Bypass you’ll get the benefit of hearing delay
and reverb trails smoothly decay when disengaging those effects.
Signal Path Routing
1>2>3 is standard operation with FX Unit 1 being the first FX in your
chain and FX Unit 3 being the last. 3>2>1 reverses this order with FX
Unit 3 being the first and FX Unit 1 being last. Hey, whatever floats
your boat!
DIM ON / OFF
Enables the dimly lit footswitch LED’s when effect memories are by-
passed (on) or disables them (off).
Relative / Absolute Pots
In REL mode when you turn a knob the parameters will not jump to the
position of the knob but change proportionally to the amount of your
parameter knob movement up or down. When set to ABS it is not pos-
sible to make incremental edits of an effect parameter. The parameter
value always adjusts from the current pot position.
FX3:PDL1 LPR:PDL2
FX2:PDL1 FX1:PDL1
Expression Pedals Tempo
120 BPM
Tempo
Use TEMPO to manually adjust your TAP tempo from 30 to 240 BPM
instead of using the TAP footswitch.
Expression Pedals
The remaining four parameters of this setup page are for Expression
Pedal operation. Download the Advanced User Guide at www.line6.
com/manuals for details.
DECAY v1.00
CONTRAST THRESH
MIDI Gate Display
DUMP EDIT?
CH 1
MIDI ,
Use “ DUMP ” to backup a scene, scene folder or all four folders to your
computer. You can also restore the factory settings. The second param-
eter is for assigning the MIDI channel your M9 Stompbox modeler sends
and receives. Get the Advanced Guide at www.line6.com for details and
download the Line 6 Monkey utility software to check for available
upgrades and updates of the M9 Stompbox modeler firmware.
Gate
Think of the Gate as a special additional pedal that applies to each
scene. There is no footswitch control for this effect so only use it when
you always want the gate engaged.
Contrast
This sets the brightness of display.