Cortelco 2740 User Manual
Page 12
7
2740 User Manual Version 1.11
j.
Repeat the steps above using the telephone numbers for Lines 3 and 4 if applicable. Remember
that Lines 2, 3, and 4 may not be common at all telephones.
2.
SYSTEM PROGRAMMING
2.1
Station Number Assignment
Each station must be assigned a unique station number. 2740 telephones will not function correctly
until a station number is assigned. To assign a number to a station:
a.
Press MENU. The display will read “Phone Setting”
b.
Press the soft key under ENTER. The display will show the currently assigned station number.
c.
Press the soft key under CHANGE repeatedly, until the desired station number is
displayed. The choices are Station #01 through Station #16.
d.
Press MENU to exit.
Note: One phone in the system must be set as Station #01 in order for all the system features to
function. Certain Features can only be programmed at station 01 and will only function at station 01.
2.2
Station Name Assignment
You may give a name to each of your telephones. During Intercom calls, the name that is assigned to
the station will show with the Extension Number. Please note that it may take up to 24 hours for all
stations to be updated with a name change. Station names must be assigned at Station 01. Follow the
steps below to assign a station name.
a.
Press MENU. The display will read “Phone Setting”
b.
Press soft key under ENTER.
c.
Press the Down Arrow repeatedly until the display reads “Station Naming”
d.
Press soft key under ENTER. The display will show the currently stored name for station
#01, or indicate “No Name” if no name has yet been given to station #01.
e.
Press soft key under CHANGE if you wish to store a new name for station #01, or press
DOWN ARROW repeatedly until you see the station number that you want to name, and then
press soft key under CHANGE.
f.
Use the dialpad numbers to enter the name for the desired station. Names may contain up to 16
characters.
g.
Press the soft key under SAVE.
Repeat these steps for any additional stations you wish to name. The following table below shows
which dialpad numbers to press for letters and special characters. Press the down arrow button below
the display to leave an empty space. Press the DELETE button to make corrections.