Cortelco 2740 User Manual
Page 14
9
2740 User Manual Version 1.11
f.
Press the soft key under NEXT to see the current setting for Line 3, and repeat steps c, d,
and e to change the settings for Lines 3-4.
g.
Press MENU to exit.
2.4
Loop Voltage Detector
The status indicators of your 2740 telephone are designed to light when a fax machine, modem, or
standard telephone is using a line. If the line status indicators of your 2740 telephones light when no
telephone is using the line or do not light when a standard telephone is using the line, the loop voltage
detector setting may need to be adjusted. The factory setting of 48 volts is appropriate for most
installations. This value can be changed to either 24 volts or 12 volts or the feature can be turned off.
To set Loop Voltage Detector
a.
Press MENU.
b.
Press DOWN ARROW repeatedly until “Advanced Setting” appears in the display.
c.
Press soft key under ENTER.
d.
Press DOWN ARROW repeatedly until “Loop Detect:” appears in the display, along with
the current setting
e.
Press the soft key under CHANGE repeatedly until the desired loop detect setting is
displayed. The choices are:
Loop Detect: 48V (factory setting)
Loop Detect: 24V (24 volts)
Loop Detect: 12V
Loop Detect: OFF
f.
Press MENU to exit.
If a line indicator at your 2740 telephone stays lit because there is no telephone line connected, and you
wish to turn it off, do not use this feature, but set this line at this station to UNCONNECTED
2.5
Ringer Configuration
The ringers for each outside line are controlled individually at each telephone. There are three possible
settings for each line ringer:
RINGER ON: The line will ring normally.
DELAYED RING: The line will start ringing after the first 20 seconds. This is useful if all phones are
answered at a central location.
RINGER OFF: The line will not ring. In all these cases, the line indicators will flash to signal an
incoming call.
You can always answer a ringing line, whether or not it is ringing audibly at your telephone, by
pressing the flashing line button.
2.5.1 Ring Timing
a.
Press MENU. The display will read “Phone Setting”
b.
Press soft key under ENTER.
c.
Press the Down Arrow repeatedly until “Ringer Settings” appears in the display.
d.
Press soft key under ENTER. The display will show the current ringer setting for Line 1.
e.
Press the soft key under CHANGE repeatedly, until the desired ringer setting for Line 1 is
displayed. The choices are:
L1 Ringer: ON (factory setting)