Cortelco 2740 - Manual (Page 30)

25 2740 User Manual Version 1.11
Note: Turning Toll Restriction ON at a telephone will have no effect unless restrictions have been
stored at that telephone.
5.15 Timer
5.15.1 Elapsed Call Time
The display automatically shows the elapsed time during a call.
5.15.2 Timer Reset
Press the up arrow (^) button, which is found directly below the display.
5.15.3 Elapsed Call Time (Previous Calls)
While the phone is on-hook and idle, press REDIAL. The display will show the elapsed time of the
previous call, along with its time and date. Use the right arrow button under the display to view the
lengths of the previous five calls, along with their times and dates.
5.16 Headset
The 2740 is equipped with a 2.5mm headset jack, and a built-in headset amplifier, along with a
dedicated HEADSET button. To use this feature, plug a telephone headset with a 2.5 millimeter plug
into the headset jack. There is no need to buy a headset with a separate amplifier. The headset can be
used to make or answer an outside call, an intercom call or a page. Simply press HEADSET instead of
lifting the handset.
To make a headset call on a particular line, press the desired LINE button to connect to that line on the
speakerphone. Then press HEADSET to toggle to the headset. Press HEADSET again to hang up.
5.17 Directory Card
This card can be used to record the names or telephone numbers associated with memory locations.
5.18 Memory Dial
Press the memory button where the desired telephone number is stored. The speakerphone will activate
and the number will be dialed out. Lift the handset or press HEADSET to switch to a handset or
headset call.
5.19 Personal Directory
a. While the phone is on-hook and idle, press the “#” button. The display will read
“Directory.”
b. Use the up and down arrow buttons below the display to view the personal directory
entries.
c. When the desired entry is displayed, it may be dialed by lifting the handset, pressing
SPEAKER or HEADSET, or by pressing a LINE button.
Note: The directory is organized alphabetically. To jump to a particular entry, press the corresponding
dial pad number. For example, press the “5” dial pad button three times to jump to the first entry
starting with “L”. You can then use the up and down arrow buttons to view the entries starting at that
point.
5.20 Predialing
Predialing allows the entry of a telephone number on the display before it is dialed out. To make a
predialed call, enter the number using the dialpad while the telephone is on-hook. Then lift the
handset, press SPEAKER or HEADSET or press the desired LINE button. Press DELETE to erase