Vermont Casting 1945 - Manual (Page 15)

15
Defiant Woodburning Stove
30001693
48"
(1220mm)
48"
(1220mm)
48"
(1220mm)
ST498
Defiant
Wall shield B
11/00
Fig. 17 Parallel installation with rear wall pass-through, two
wall shields. Reduced clearances to both rear and side walls.
Wall shields may meet at corner if desired. Wall pass-through
must comply with codes.
Refer to “Special Installations.”
ST498
48"
(1220mm)
48"
(1220mm)
48"
(1220mm)
48"
(1220mm)
ST499
Defiant
Wall Shield C
11/00
ST499
Fig. 18 Corner installation, vertical chimney connector, two
wall shields. Reduced side clearances. Wall shield MUST
meet at corner.
Stove Heat Shields
The Vermont Castings Defiant Rear Heat Shield, shown
below, is one way to reduce the clearance to the rear
wall. The rear heat shield can be installed in any set-
ting. However, since the chimney connector also radi-
ates heat toward the wall, you must use a chimney con-
nector shield whenever you use the rear heat shield.
Clearance reductions with the rear heat shield apply
only to the wall to the rear in parallel installations. Nei-
ther the side clearance requirement nor the clearance
requirement in corner installations may be reduced.
48"
(1220mm)
48"
(1220mm)
48"
(1220mm)
48"
(1220mm)
ST497
Defiant
wall shield A
11/00
Fig. 16 Parallel installation, vertical chimney connector, two
wall shields. Reduced clearances for both rear and side walls.
Wall shields may meet at corner if desired. Shielding for con-
nector is centered behind connector.
ST497
Fig. 19 Defiant rear heat shield with flue collar heat shield for
top exit configuration.
Flue Collar Heat
Shield
Rear Heat
Shield
Spacers
Truss Head
Phillips Screws
KT287
Bend